Customize your felt book cover with a notebook pocket, faux button closure, or penholder.

MATERIALS:
Felt
Ruler
Scissors
Pins
Embroidery thread and needle
Button (optional)
Self-adhesive Velcro dot (optional)

DIRECTIONS

1.To make a cover, open your chosen book and measure the width and height. Add one inch to each measurement and cut out a piece of felt with those dimensions. For the inside flaps, cut two additional pieces of felt the same height as the main piece and two-thirds the width of the closed book’s front cover.

2.Lay an inside flap on top of each end of the main piece and pin the flaps and the main piece together. With embroidery thread, sew a running stitch about 1/4 inch to 3/8 inch from the edge around the entire border.

3.If you like, add one of these extras:

Notebook pocket: Before attaching the inside flaps, cut a piece of felt that’s 1 1/2 inches wider and 1/2 inch shorter than your notepad. Sew it in the center of what will be the front cover of the book.

Faux button closure: Before attaching the inside flaps, cut a strap that’s 1 1/2 inches wide and as long as the width of an inside flap. Sandwich the strap between the back flap and the cover and pin it in place, then sew around the entire edge of the cover, as noted above. With scissors, round the end of the strap and sew on a button. Affix a self-adhesive Velcro dot to the strap and the front of the cover.

Penholder: After the cover is finished and on the book, cut a 1 3/4-inch square out of felt. With the book cIosed, lay the square over a pen on the book’s spine and pin it in place. Take the cover off the book, then sew on the square.

(Source: http://familyfun.go.com/)